WINDOW DEFOGGER WIRE > REPAIR

for Preparation Click here



1. IF NECESSARY, REPAIR THE DEFOGGER WIRE


B106758E01

  1. Clean the broken wire tips with grease, wax and silicone remover.

  1. Place the masking tape along both sides of the wire.



    B106759

  1. Thoroughly mix the repair agent (Dupont paste No. 4817 or equivalent).

  1. Using a fine tip brush, apply a small amount of the agent to the wire.

  1. After a few minutes, remove the masking tape.

    NOTICE:
    Do not repair the defogger wire again for at least 24 hours.