POWER TILT AND POWER TELESCOPIC STEERING COLUMN > FAIL-SAFE CHART

for Preparation Click here



FAIL-SAFE OPERATION 
DTC No.
Detection Item
Fail-safe
B2602
Auto Function Activation Condition Error
Auto away function stops.
Auto return function:
  1. Continues (when the ignition switch is in the ON position)
  2. Stops (when the ignition switch is off)
B2610
Tilt Position Sensor or Tilt Motor Circuit Malfunction
Tilt operation is suspended.
B2611
Telescopic Position Sensor or Telescopic Motor Circuit Malfunction
Telescopic operation is suspended.
B2620
ECU Power Source Circuit Malfunction
Tilt and telescopic operation is suspended.
B2624
Speed Signal Malfunction
Auto away and/or auto return function stops.

HINT:
If the power voltage to the ECU returns to normal within 10 seconds during tilt or telescopic operation, the operation will be resumed. If it returns to normal after 10 seconds have elapsed, the operation restarts when a tilt or telescopic operation signal is reinput to the ECU.

  1. If the communication of an ECU related to this system is interrupted, the ECU effects the controls listed below. (Example: When the windshield wiper switch assembly (combination switch ECU) is defective, manual operation is not available but the auto away/return and position memory functions can operate.)

    Tilt and Telescopic Operation
    		Driver side J/B ECU
    (Body ECU)
    Communication
    Interruption
    		Position Control ECU and Switch Assembly
    (Driver seat ECU)
    Communication
    Interruption
    		All ECUs*
    Communication
    Interruption
    Manual
    		○
    (IG switch ON position)
    		○
    		○
    (IG switch ON position)
    Auto away/return
    		X
    		○
    		X
    Position memory
    (Memorization)
    		X
    		X
    		X
    Position memory
    (Reproduction)
    		○
    (IG switch ON position)
    		X
    		X
    ○: Operate
    X: Not operate