POWER TILT AND POWER TELESCOPIC STEERING COLUMN > FREEZE FRAME DATA

for Preparation Click here



FREEZE FRAME DATA

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to the ON position and check the freeze frame data by following the prompts on the intelligent tester screen.

    Tilt & Telescopic: 
    Item
    		Measurement Item/ Range (Display)
    		Normal Condition
    		Diagnostic Note
    Tilt Position
    		Current tilt position data/min.: 0000 H (0 edge), max.: FFFF H (65535 edge)
    		7000 to 9000 H
    (28672 to 36864 edge)
    		-
    Telesco Position
    		Current telescopic position data/ min.: 0000 H (0 edge), max.: FFFF H (65535 edge)
    		7000 to 9000 H
    (28672 to 36864 edge)
    		-
    Up Switch
    		Communication state of tilt up input by manual switch/ON or OFF
    		ON: Tilt up is activated by manual switch
    OFF: Tilt up is not activated by manual switch
    		-
    Down Switch
    		Communication state of tilt down input by manual switch/ON or OFF
    		ON: Tilt down is activated by manual switch
    OFF: Tilt down is not activated by manual switch
    		-
    Short Switch
    		Communication state of telescopic short input by manual switch/ON or OFF
    		ON: Telescopic short is activated by manual switch
    OFF: Telescopic short is not activated by manual switch
    		-
    Long Switch
    		Communication state of telescopic long input by manual switch/ON or OFF
    		ON: Telescopic long is activated by manual switch
    OFF: Telescopic long is not activated by manual switch
    		-
    T&T Manual SW Data
    		Voltage data of manual switch/ min.: 0 V, max.: 5 V
    		Neutral position: Below 0.2 V
    Tilt up: 1.67 to 2.13 V
    Tilt down: 0.54 to 0.74 V
    Telescopic contract: 1.08 to 1.40 V
    Telescopic extend: 2.22 to 2.77 V
    		-
    Power Source Voltage
    		Voltage data of power supply/min.: 0 V, max.: 20 V
    		Actual power supply voltage
    10 to 14 V
    		-
    Freeze Speed Info
    		Vehicle speed data/0 km/h (0 mph), max.: 255 km/h (158 mph)
    		Available only for vehicles with the freeze frame data
    		-
    IG Switch (MPX)
    		Communication state of ignition switch/ON or OFF
    		ON: Communication is normal
    OFF: Communication is interrupted
    		-
    IG Switch
    		Input state of ignition switch/ON or OFF
    		ON: Input signal is normal
    OFF: Input signal is interrupted
    		-
    KEY Switch/MPX
    		Communication state of unlock warning switch/ON or OFF
    		ON: Communication is normal
    OFF: Communication is interrupted
    		-
    Receive from Body
    		Communication state of body ECU signal/OK or Interruption
    		OK: Communication is normal Interruption: Communication is interrupted
    		-
    Receive from Seat ECU
    		Communication state of seat ECU signal/OK or Interruption
    		OK: Communication is normal Interruption: Communication is interrupted
    		-
    Receive from Seat Combi
    		Communication state of combination switch ECU signal/OK or Interruption
    		OK: Communication is normal Interruption: Communication is interrupted
    		-
    Receive from Meter
    		Communication state of combination meter signal/OK or Interruption
    		OK: Communication is normal Interruption: Communication is interrupted
    		-