DTC    C1210/36    Zero Point Calibration of Yaw Rate Sensor Undone

DTC    C1336/98    Zero Point Calibration of Deceleration Sensor Undone

for Preparation Click here


DESCRIPTION


DTC No.
INF Code
DTC Detecting Condition
Trouble Area
C1210/36
336
Yaw rate sensor zero point calibration is unfinished.
  1. Zero point calibration undone (Perform zero point calibration and check DTC. If DTC is not output again, the sensor is normal.)
  2. Yaw rate and deceleration sensor
C1336/98
318
  1. Vehicle speed increases with unfinished zero point calibration.
  2. Zero point calculation is not within specified range when zero point calibration is finished.
  1. Zero point calibration undone (Perform zero point calibration and check DTC. If DTC is not output again, the sensor is normal.)
  2. Yaw rate and deceleration sensor

INSPECTION PROCEDURE

1.PERFORM ZERO POINT CALIBRATION OF YAW RATE AND DECELERATION SENSOR

  1. Perform the zero point calibration of the yaw rate and deceleration sensor. (Click here).


NEXT


2.RECONFIRM DTC

  1. Clear the DTCs (Click here).

  1. Turn the ignition switch on.

  1. Check the same DTCs are recorded (Click here).

    Result:

    Condition
    		Proceed To
    DTC is not output
    		A
    DTC is output
    		B



B
REPLACE YAW RATE AND DECELERATION SENSOR
A

END