AIR CONDITIONING SYSTEM > IG Power Source Circuit

for Preparation Click here


DESCRIPTION

This is the main power source supplied to the A/C amplifier assembly when the ignition switch is turned to the ON position. The power source is used for operating the A/C amplifier assembly and servomotor, etc.

WIRING DIAGRAM


E109245E03


INSPECTION PROCEDURE

1.INSPECT ECU-IG NO.1 FUSE

  1. Remove the ECU-IG No.1 fuse from the instrument panel J/B.

  1. Measure the resistance to the value(s) in the table below.

    Resistance:

    Tester item
    		Condition
    		Specified condition
    ECU-IG NO.1 fuse
    		Always
    		Below 1 Ω



NG
REPLACE ECU-IG NO.1 FUSE
OK


2.INSPECT AIR CONDITIONING AMPLIFIER ASSEMBLY


    E109265E29

  1. Remove the A/C amplifier assembly with the connectors still connected.

  1. Measure the voltage according to the value(s) in the table below.

    Voltage:
    Tester connection
    (Symbols)
    		Condition
    		Specified condition
    A11-1 (IG+) - A11-6 (GND)
    		Ignition switch ON
    		10 to 14 V



NG
Go to step 3
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE 

3.CHECK HARNESS AND CONNECTOR (A/C AMPLIFIER ASSEMBLY - BODY GROUND)


    E109218E21

  1. Disconnect the connector from the A/C amplifier assembly.

  1. Measure the voltage according to the value(s) in the table below.

    Voltage:
    Tester connection
    (Symbols)
    		Condition
    		Specified condition
    A11-1 (IG+) - Body ground
    		Ignition switch ON
    		10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (A/C AMPLIFIER ASSEMBLY - BODY GROUND)


    E109218E22

  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester connection
    (Symbols)
    		Condition
    		Specified condition
    A11-6 (GND) - Body ground
    		Always
    		Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY