DTC    C1345/66    Linear Solenoid Valve Offset Learning Undone

DTC    C1368/67    Linear Solenoid Valve Offset Malfunction

for Preparation Click here


DESCRIPTION

The skid control ECU stores and corrects the difference in each individual part such as the stroke sensor, actuator solenoids, and stroke simulator solenoid. Perform initialization of linear solenoid valve and calibration if these parts are replaced.
The skid control ECU inputs the shift position P signal.

DTC No.
INF Code
DTC Detecting Condition
Trouble Area
C1345/66
501
Value of initialization of linear solenoid valve and calibration for the FR wheel is not stored.
  1. Initialization of linear solenoid valve and calibration undone
C1345/66
502
Value of initialization of linear solenoid valve and calibration for the FL wheel is not stored.
  1. Initialization of linear solenoid valve and calibration undone
C1345/66
503
Value of initialization of linear solenoid valve and calibration for the RR wheel is not stored.
  1. Initialization of linear solenoid valve and calibration undone
C1345/66
504
Value of initialization of linear solenoid valve and calibration for the RL wheel is not stored.
  1. Initialization of linear solenoid valve and calibration undone
C1368/67
505
Value of initialization of linear solenoid valve and calibration is not within the brake actuator's standard value.
  1. Initialization of linear solenoid valve and calibration undone
  2. Skid control ECU

INSPECTION PROCEDURE

1.PERFORM INITIALIZATION OF LINEAR SOLENOID VALVE AND CALIBRATION

  1. Perform initialization of the linear solenoid valve and calibration (Click here).


NEXT


2.RECONFIRM DTC

  1. Clear the DTCs (Click here).

  1. Turn the ignition switch on.

  1. Check the same DTCs are recorded (Click here).

    Result:

    Condition
    		Proceed To
    DTC is not output
    		A
    DTC is output
    		B



B
REPLACE BRAKE ACTUATOR ASSEMBLY
A

END