BLOWER UNIT > INSTALLATION

for Preparation Click here



1. INSTALL BLOWER ASSEMBLY


    E111242

  1. Install the blower assembly with the claw.

  1. Install the bolt and 2 screws.

    Torque:
    BOLT:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }



    I036021E01

  1. Install the bracket with the 4 screws and nut.

    Torque:
    NUT:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }



    E110821

  1. Install the clamp and connect the connectors.



2. INSTALL WIRING AIR INDICATOR HARNESS NO.2 SUB-ASSEMBLY


3. INSTALL AIR DUCT NO.2


    E110819

  1. Install the air duct No.2 with the screw.

    Torque:
    2.5 N*m{ 25 kgf*cm , 22 in.*lbf }



4. INSTALL HYBRID VEHICLE CONTROL ECU

  1. Install the hybrid vehicle control ECU with the 2 nuts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Connect the 6 connectors to the hybrid vehicle control ECU.

  1. Connect the 3 wire harness clamps.



5. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY


    B108513E03

  1. Connect the connectors.

  1. Install the 2 bolts <A>, the 2 screws <C>, and the glove compartment door assembly.



6. INSTALL INSTRUMENT PANEL UNDER COVER NO.2 SUB-ASSEMBLY


    B112171

  1. Connect the connectors.

  1. Engage the 3 claws and install the instrument panel No.2 under cover sub-assembly.



7. INSTALL COWL SIDE TRIM RH SUB-ASSEMBLY


8. INSTALL FRONT DOOR SCUFF PLATE RH


9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


10. PERFORM INITIALIZATION

NOTICE:
Some systems need initialization when disconnecting the cable from the negative battery terminal. (Click here)