CONDENSER > REASSEMBLY

for Preparation Click here

1. Using needle nose pliers, install the cooler dryer.
   

2. Install a new O-ring to the cap.
   

3. Sufficiently apply compressor oil to the fitting surfaces of the O-ring and the cap.
   

   Compressor oil:

   ND-OIL 11 or equivalent
   

   NOTICE:

   1. Do not use any compressor oil other than ND-OIL 11 or equivalent.
      
   2. If any compressor oil other than ND-OIL 11 or equivalent is used, compressor motor insulation performance may decrease, resulting in leakage of electric power.
      

4. Using hexagon wrench 14 mm, install the cap to the cooler condenser assembly.
   

   Torque:

   2.9 N*m{ 30 kgf*cm , 25 in.*lbf }