TRANSMITTER BATTERY > REPLACEMENT

for Preparation Click here



1. REMOVE TRANSMITTER BATTERY


    B111424

  1. Remove the cover.



    B111425

  1. Using a coin, or other flat object, pry open the transmitter cover.

  1. Remove the transmitter battery (lithium battery).

    NOTICE:
    1. Do not push the terminals with your finger.
    2. Forcibly prying up the battery (lithium battery) to remove it will deform the terminals.
    3. Do not touch the battery with wet hands. Water may cause rust.
    4. Do not touch or move any components inside the transmitter because handling the components may interfere with proper operation of the transmitter.



2. INSTALL TRANSMITTER BATTERY


    B111426

  1. Install a new battery (lithium battery) with the positive (+) side up as shown in the illustration.

    NOTICE:
    1. Be sure that the positive side and the negative side of the transmitter battery are matched correctly.
    2. Be careful not to bend the terminals of the transmitter battery during installation.
    3. Be careful that dust and oil do not come into contact with the transmitter case.

  1. Install the cover.

    NOTICE:
    If the screws are loose, it may cause faulty contact between the battery (lithium battery) and the terminals.