SLIDING ROOF HOUSING > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE ROOF HEADLINING ASSEMBLY
(Click here)


3. REMOVE CURTAIN SHIELD LH AIRBAG ASSEMBLY

  1. Disconnect the connector from the curtain shield airbag assembly LH.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



  1. Remove the 9 bolts and the curtain shield airbag assembly LH in the order shown in the illustration.


    H042752E01



4. REMOVE CURTAIN SHIELD RH AIRBAG ASSEMBLY


5. REMOVE SLIDING ROOF SIDE LH GARNISH


    B110467

  1. Disengage the 5 claws and remove the sliding roof side garnish.



6. REMOVE SLIDING ROOF SIDE RH GARNISH


7. REMOVE SLIDING ROOF GLASS SUB-ASSEMBLY


    B110468

  1. Using a T25 "torx" driver, remove the 4 screws and sliding roof glass sub-assembly.



8. REMOVE SLIDING ROOF HOUSING SUB-ASSEMBLY


    B113440

  1. Disconnect the 4 sliding roof drain hoses.

  1. Remove the 4 bolts, 8 nuts, and sliding roof housing sub-assembly.