SLIDING ROOF HOUSING > REASSEMBLY

for Preparation Click here



1. INSTALL SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY


    B110471

  1. Using a screwdriver, slide the sliding roof drive cable sub-assembly in the direction indicated by the arrow in the illustration to install it.

    NOTICE:
    Check and be sure that the spring indicated by the arrow in the illustration is securely installed.

    HINT:
    Tape the screwdriver tip before use.



    B110472

  1. Engage the 2 claws and install the sliding roof drip channel.

  1. Install the 2 sliding roof guide stoppers with the 2 screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }



2. ADJUST FULLY CLOSED POSITION


    B110473E01

  1. Using a screwdriver, slide the sliding roof drive cable sub-assembly in either direction as indicated by the arrows in the illustration and align the matchmarks.

    HINT:
    Tape the screwdriver tip before use.



3. INSTALL SUNSHADE TRIM SUB-ASSEMBLY

  1. Insert the sunshade trim into the sliding roof housing sub-assembly.

  1. Install the sliding roof LH and RH piece sub-assemblies with the 2 screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }



4. INSTALL SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY


    B110476

  1. Install the sliding roof drive gear sub-assembly with the 2 bolts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



    B110462

  1. Engage the claw and install the sliding roof drive gear bracket.