PARKING BRAKE CABLE > REMOVAL

for Preparation Click here



1. REMOVE REAR WHEEL


2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY


    C108172

  1. Remove the 2 bolts and separate the rear disc brake caliper assembly.

    HINT:
    Do not disconnect the flexible hose from the rear disc brake caliper assembly.



3. REMOVE REAR DISC


    C110872E01

  1. Release the parking brake.

  1. Put matchmarks on the rear disc and the axle hub.



    C108703E01

  1. Remove the rear disc.

    HINT:
    If the disc cannot be removed easily, turn the shoe adjuster until the wheel turns smoothy.



4. REMOVE PARKING BRAKE SHOE STRUT


    C108696

  1. Using needle-nose pliers, remove the 2 parking brake shoe return tension No.1 springs.

  1. Remove the parking brake shoe strut and parking brake shoe strut compression spring.



5. REMOVE PARKING BRAKE NO.1 SHOE ASSEMBLY


    C108698E01

  1. Remove the parking brake shoe hold down spring No.1 cup, parking brake shoe hold down spring and parking brake shoe hold down spring No.2 cup.

  1. Disconnect the parking brake shoe return tension No.2 spring and remove the parking brake No.1 shoe assembly.



6. REMOVE PARKING BRAKE SHOE ADJUSTING SCREW SET


    F045549E01

  1. Remove the parking brake shoe adjusting screw set.

  1. Remove the parking brake shoe return tension No.2 spring.



7. REMOVE PARKING BRAKE NO.2 SHOE ASSEMBLY


    C108699E01

  1. Remove the parking brake shoe hold down spring No.1 cup, parking brake shoe hold down spring and parking brake shoe hold down spring No.2 cup.

  1. Remove the parking brake shoe hold down spring No.2 pin.

  1. Remove the parking brake No.2 shoe assembly.



    C108700

  1. Using needle-nose pliers, disconnect the parking brake No.3 cable assembly from the parking brake cable shoe lever.

    NOTICE:
    Be careful not to damage parking brake No.3 cable assembly.



8. SEPARATE PARKING BRAKE NO.3 CABLE ASSEMBLY


    C108694

  1. Remove the 2 bolts and separate the parking brake No.3 cable assembly from the backing plate.



9. REMOVE FUEL TANK NO.1 PROTECTOR


    A108198

  1. Disengage the 4 grommets.

  1. Remove the screw and fuel tank protector sub-assembly No.1.



10. REMOVE PARKING BRAKE NO.3 CABLE ASSEMBLY

  1. Remove the 2 bolts and separate the parking brake No.2 and No.3 cable assemblies from the parking brake equalizer.



  1. Remove the bolt, 4 nuts, and parking brake No.3 cable assembly.


    C108695

  1. Remove the parking brake cable support No.1 bracket.