REAR SEAT ASSEMBLY (for 60/40 Split Seat Type RH Side) > REMOVAL

for Preparation Click here

1. Move the rear seat assembly RH to the rearmost position by operating the rear seat track adjusting handle.
   

2. Using a screwdriver, disengage the 4 claws.
   

   HINT:

   Tape the screwdriver tip before use.

3. Pull the 2 rear seat track bracket covers toward the rear of the vehicle and remove them.
   

1. Using a clip remover, remove the 5 clips.
   

2. Remove the bolt and disconnect the floor anchor side of the fold seat stopper band assembly No.1.
   

3. Move the rear seat assembly RH to the rearmost position by operating the rear seat track adjusting handle.
   

4. Remove the 2 bolts on the front side.
   

5. Move the rear seat assembly RH fully forward by operating the rear seat track adjusting handle.
   

6. Remove the 3 bolts on the rear side.
   

7. Move the rear seat assembly RH to the center position and adjust the seatback to the vertical position.
   

8. Remove the rear seat assembly RH.