FRONT SEAT OUTER BELT ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working (Click here).



2. REMOVE FRONT DOOR SCUFF PLATE


    B111782

  1. Disengage the 6 claws and 4 clips, and remove the front door scuff plate.

  1. Disconnect the connector. (w/ illumination scuff plate)



3. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP


4. REMOVE REAR DOOR SCUFF PLATE


    B111783

  1. Disengage the 4 claws and 2 clips, and remove the rear door scuff plate.

  1. Disconnect the connector. (w/ illumination scuff plate)



5. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP


6. REMOVE LAP BELT OUTER ANCHOR COVER


    B115711E01

  1. Disengage the 2 claws and remove the lap belt outer anchor cover.



7. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY

  1. Remove the bolt and disconnect the floor side of the front seat outer belt assembly.



8. REMOVE CENTER PILLAR GARNISH LOWER


    B111788

  1. Disengage the 3 claws and 2 clips, and remove the center pillar garnish lower.



9. REMOVE CENTER PILLAR GARNISH


    B111789

  1. Remove the 2 screws.

  1. Disengage the clip and remove the center pillar garnish by pulling it down.



10. REMOVE FRONT SEAT OUTER BELT ASSEMBLY

  1. Turn the ignition switch to the LOCK position.

  1. Remove the nut and disengage the shoulder side of the front seat outer belt assembly.



    B112617

  1. Using a screwdriver, pull out the locking button in the direction shown by the arrow to release the lock, and disconnect the pretensioner connector.

    HINT:
    Tape the screwdriver tip before use.

  1. Disconnect the tension reducer connector.



    B115712

  1. Remove the 2 bolts and front seat outer belt assembly.