FRONT SEAT INNER BELT ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE SEAT TRACK BRACKET COVER OUTER FRONT LH


    B112092E01

  1. Move the front seat assembly to the rearmost position by operating the slide and vertical power seat switch knob.

  1. Using a screwdriver, disengage the 3 claws and remove the seat track bracket cover outer front LH.

    HINT:
    Tape the screwdriver tip before use.



2. REMOVE SEAT TRACK BRACKET COVER INNER FRONT LH


    B112093E01

  1. Using a screwdriver, disengage the 2 claws and remove the seat track bracket cover inner front LH.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE SEAT TRACK COVER RH


    B112094E01

  1. Move the front seat assembly fully forward by operating the slide and vertical power seat switch knob.

  1. Using a screwdriver, disengage the 4 claws and remove the seat track cover LH.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE SEAT TRACK COVER LH

  1. Using a screwdriver, disengage the 4 claws and remove the seat track cover RH.

    HINT:
    Tape the screwdriver tip before use.



5. REMOVE FRONT SEAT ASSEMBLY

  1. Move the front seat assembly to the rearmost position by operating the slide and vertical power seat switch knob.

  1. Remove the 2 bolts on the front side.

  1. Move the front seat assembly fully forward by operating the slide and vertical power seat switch knob.

  1. Remove the 2 bolts on the rear side.

  1. Move the front seat assembly to the center position and adjust the seatback to the vertical position by operating the slide and vertical power seat switch knob and the reclining power seat switch knob.

  1. Turn the ignition switch to the LOCK position.

  1. Disconnect the negative battery cable from the battery, and wait 90 seconds or more.

    CAUTION:
    Wait 90 seconds or more after disconnecting the negative terminal cable to prevent the airbag from working (Click here ).

  1. Disconnect the connectors and clamp.

  1. Remove the front seat assembly.

    NOTICE:
    When removing the passenger side front seat assembly, be careful not to step on the yaw rate sensor mounted on the floor under the seat.



6. REMOVE RECLINING POWER SEAT SWITCH KNOB

  1. Using a screwdriver, remove the reclining power seat switch knob.

    HINT:
    Tape the screwdriver tip before use.



7. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB

  1. Using a screwdriver, remove the slide and vertical power seat switch knob.

    HINT:
    Tape the screwdriver tip before use.



8. REMOVE FRONT SEAT CUSHION SHIELD ASSEMBLY

  1. Release the 2 rubber bands on the backside of the front seatback board sub-assembly.

  1. Remove the 7 screws.

  1. Disengage the 4 claws and clip, and remove the front seat cushion shield assembly as shown in the illustration.

  1. Driver seat only:

    1. Disconnect the power seat switch assembly connector.



  1. Remove the front seat cushion shield assembly.


    B068210E01



9. REMOVE FRONT SEAT INNER BELT ASSEMBLY


    B115709

  1. Disconnect the connectors.

  1. Remove the 4 clamps.

  1. Remove the nut and front seat inner belt assembly.