NAVIGATION SYSTEM > Navigation ECU Power Source Circuit

for Preparation Click here


DESCRIPTION

This is the power source circuit to operate the navigation ECU.

WIRING DIAGRAM


E110882E03


INSPECTION PROCEDURE

1.INSPECT NAVIGATION ECU


    E111733E08

  1. Disconnect the navigation ECU connector N4.

  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester connection
    		Condition
    		Specified condition
    GND1 - Body ground
    		Always
    		Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Voltage:
    Tester connection
    		Condition
    		Specified condition
    +B - GND1
    		Always
    		10 to 14 V
    ACC - GND1
    		Ignition SW ACC
    		10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

RETURN TO THE ORIGINAL INSPECTION FLOW BECAUSE THE CHECK RESULT IS NORMAL