FRONT POWER SEAT CONTROL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use this procedure to troubleshoot the front power seat control system.
  2. The intelligent tester should be used in steps 3 and 5.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS CHECK AND PROBLEM SYMPTOM CHECK

      NEXT


      3.CHECK COMMUNICATION FUNCTION OF MULTIPLEX COMMUNICATION SYSTEM (BEAN)

      1. Use the intelligent tester to check for normal function of the multiplex communication system.

        1. (Position control ECU and switch assembly (Power seat control switch and ECU) not connected, communication line malfunctioning) If no code is output, proceed to A.

        2. (Position control ECU and switch assembly (Power seat control switch and ECU) not connected, communication line malfunctioning) If any code is output, proceed to B.



      		B.
      Go to MULTIPLEX COMMUNICATION SYSTEM
      A


      4.PROBLEM SYMPTOMS TABLE

      1. If the fault is not listed on the problem symptoms table, proceed to A.

      2. If the fault is listed on the problem symptoms table, proceed to B.



      		B.
      Go to step 6
      A


      5.OVERALL ANALYSIS AND TROUBLESHOOTING

      1. DATA LIST/ACTIVE TEST (Click here).

        1. Inspection with the intelligent tester (DATA LIST).

        2. Inspection with the intelligent tester (ACTIVE TEST).

      2. Terminals of ECU (Click here).

      3. Inspection.


      NEXT


      6.ADJUST, REPAIR OR REPLACE

        NEXT


        7.CONFIRMATION TEST

          NEXT

          END