FRONT POWER SEAT CONTROL SYSTEM > DIAGNOSIS SYSTEM

for Preparation Click here



DESCRIPTION

  1. Front power seat control system data can be read through the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the intelligent tester to check for malfunctions and perform repairs.


CHECK DLC3


    A082779E09

  1. The vehicle uses ISO 9141-2 (Euro-OBD) communication protocol. The terminal arrangement of the DLC3 complies with ISO 15031-3 and matches the ISO 9141-2 format.

    Symbols (Terminal No.)
    		Terminal Description
    		Condition
    		Specified Condition
    SIL(7) - SG(5)
    		Bus "+" line
    		During transmission
    		Pulse generation
    CG(4) - Body ground
    		Chassis ground
    		Always
    		Below 1 Ω
    SG(5) - Body ground
    		Signal ground
    		Always
    		Below 1 Ω
    BAT(16) - Body ground
    		Battery positive
    		Always
    		11 to 14 V
    If the result is not as specified, the DLC3 may have a malfunction. Repair or replace the wire harness and connector.

    HINT:
    Connect the cable of the intelligent tester to the DLC3, turn the ignition switch on and attempt to use the tester. If the screen displays a communication error message, a problem exists on the vehicle side or the tester side.
    1. If communication is normal when the tester is connected to another vehicle, inspect the DLC3 of the original vehicle.
    2. If communication is still not possible when the tester is connected to another vehicle, the problem is probably in the tester itself. Consult the Service Department listed in the tester's instruction manual.


INSPECT BATTERY VOLTAGE

  1. Check the battery voltage.

    Voltage:
    11 to 14 V

    If the voltage is below 11 V, recharge or replace the battery before proceeding.