SEAT MEMORY SWITCH > INSPECTION

for Preparation Click here



1. INSPECT SEAT MEMORY SWITCH


    B068340E01

  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester Connection
    		Switch Position
    		Specified Condition
    1(E) - 2(MMRY)
    		SET switch ON (pushed)
    		Below 1 Ω
    1(E) - 2(MMRY)
    		SET switch OFF (not pushed)
    		10 kΩ or higher
    1(E) - 4(1)
    		SW1 switch ON (pushed)
    		Below 1 Ω
    1(E) - 4(1)
    		SW1 switch OFF (not pushed)
    		10 kΩ or higher
    1(E) - 3(2)
    		SW2 switch ON (pushed)
    		Below 1 Ω
    1(E) - 3(2)
    		SW2 switch OFF (not pushed)
    		10 kΩ or higher

    If the result is not as specified, replace the switch.