FRONT POWER SEAT LUMBAR SWITCH > INSPECTION

for Preparation Click here



1. INSPECT FRONT POWER SEAT LUMBAR SWITCH


  1. Inspect the LH side front power seat lumbar switch.



      B113016E01

    1. Measure the resistance according to the value(s) in the table below.

      Resistance:
      Tester Connection
      		Switch Position
      		Specified Condition
      1(R) - 2(E2)
      		HOLD
      		Below 1 Ω
      3(B) - 4(H)
      		HOLD
      		Below 1 Ω
      1(R) - 2(E2)
      		OFF
      		Below 1 Ω
      4(H) - 5(E1)
      		OFF
      		Below 1 Ω
      1(R) - 3(B)
      		RELEASE
      		Below 1 Ω
      4(H) - 5(E1)
      		RELEASE
      		Below 1 Ω

      If the result is not as specified, replace the switch.



  1. Inspect the RH side front power seat lumbar switch.



      B113017E04

    1. Measure the resistance according to the value(s) in the table below.

      Resistance:
      Tester Connection
      		Switch Position
      		Specified Condition
      1(R) - 2(E2)
      		HOLD
      		Below 1 Ω
      3(B) - 4(H)
      		HOLD
      		Below 1 Ω
      1(R) - 2(E2)
      		OFF
      		Below 1 Ω
      4(H) - 5(E1)
      		OFF
      		Below 1 Ω
      1(R) - 3(B)
      		RELEASE
      		Below 1 Ω
      4(H) - 5(E1)
      		RELEASE
      		Below 1 Ω

      If the result is not as specified, replace the switch.