POWER STEERING GEAR > INSTALLATION

for Preparation Click here



1. INSTALL POWER STEERING LINK ASSEMBLY


    C111459

  1. Install the power steering link assembly with the 2 bolts and 2 nuts.

    Torque:
    70 N*m{ 714 kgf*cm , 52 ft.*lbf }

    NOTICE:
    Turn the bolt while holding the nut.



2. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE

HINT:
Refer to the instructions for installation of the engine assembly (Click here).



3. CONNECT TIE ROD ASSEMBLY LH

  1. Connect the tie rod assembly LH to the steering knuckle with the nut.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }

  1. Install a new cotter pin.

    NOTICE:
    Further tighten the nut up to 60° if the holes for the cotter pin are not aligned.



4. CONNECT TIE ROD ASSEMBLY RH

HINT:
Perform the same procedure as for the LH side.



5. CONNECT STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY


    C111430E01

  1. Align matchmarks on the steering intermediate shaft sub-assembly and the power steering link assembly.



    C111478

  1. Install the bolt.

    Torque:
    35 N*m{ 360 kgf*cm , 26 ft.*lbf }



    C111429E01

  1. Tighten the bolt (B).

    Torque:
    35 N*m{ 360 kgf*cm , 26 ft.*lbf }

  1. Install the clamp to the steering column hole shield and tighten the bolt (A).



6. INSTALL FRONT STABILIZER LINK ASSEMBLY LH


    C107661E04

  1. Install the front stabilizer link assembly with the nut.

    Torque:
    74 N*m{ 755 kgf*cm , 55 ft.*lbf }

    HINT:
    If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud.



7. INSTALL FRONT STABILIZER LINK ASSEMBLY RH

HINT:
Perform the same procedure as for the LH side.



8. INSTALL ENGINE UNDER COVER NO.2


9. INSTALL FRONT WHEELS

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }



10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


11. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


12. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
(Click here)


13. PERFORM INITIALIZATION

  1. Some systems need initialization when disconnecting the cable from the negative battery terminal (Click here).



14. INITIALIZE ROTATION ANGLE SENSOR AND CALIBRATE TORQUE SENSOR ZERO POINT
(Click here)