HEADLIGHT ASSEMBLY > REPAIR

for Preparation Click here



1. INSTALL HEADLIGHT PROTECTOR RETAINER UPPER

HINT:
  1. If the installation area of the headlight assembly is damaged, use the supply bracket for low-cost repair.
  2. Ensure that the headlight assembly is not damaged.



    E068365

  1. Cut off the part shaded in the illustration and sand smooth with sandpaper.

    NOTICE:
    After cutting off the part, place the headlight protector retainer upper against the bosses and gradually file away until installation is possible.



    E069115

  1. Install the headlight protector retainer upper with the 2 screws.



2. INSTALL HEADLIGHT PLATE

HINT:
  1. If the installation area of the headlight assembly is damaged, use the supply bracket for low-cost repair.
  2. Ensure that the headlight assembly is not damaged.



    E068366

  1. Cut off the part shaded in the illustration and sand smooth with sandpaper.

    NOTICE:
    After cutting off the part, place the headlight plate against the bosses and gradually file away until installation is possible.



    E069112

  1. Install the headlight plate with the screw.



3. INSTALL HEADLIGHT PROTECTOR RETAINER LOWER

HINT:
  1. If the installation area of the headlight assembly is damaged, use the supply bracket for low-cost repair.
  2. Ensure that the headlight assembly is not damaged.



    E068364

  1. Cut off the part shaded in the illustration and sand smooth with sandpaper.

    NOTICE:
    After cutting off the part, place the headlight protector retainer lower against the bosses and gradually file away until installation is possible.



    E069113

  1. Install the headlight protector retainer lower with the screw.



4. INSTALL HEADLIGHT BRACKET LOWER

HINT:
  1. If the installation area of the headlight assembly is damaged, use the supply bracket for low-cost repair.
  2. Ensure that the headlight assembly is not damaged.



    E069110

  1. Cut off the part shaded in the illustration and sand smooth with sandpaper.

    NOTICE:
    After cutting off the part, place the headlight bracket lower against the bosses and gradually file away until installation is possible.



    E069114

  1. Install the headlight bracket lower with the 2 screws.