HEADLIGHT DIMMER SWITCH > REMOVAL

for Preparation Click here



1. PRECAUTION
(Click here)


2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
(Click here)


4. REMOVE STEERING WHEEL NO.2 COVER LOWER


    C111801

  1. Using a screwdriver, remove the steering wheel No.2 cover lower.

    HINT:
    Tape up the screwdriver tip before use.



5. REMOVE STEERING WHEEL NO.3 COVER LOWER


    C111800

  1. Using a screwdriver, remove the steering wheel No.3 cover lower.

    HINT:
    Tape up the screwdriver tip before use.



6. REMOVE STEERING PAD ASSEMBLY


    C111802E01

  1. Using a "torx" socket wrench (T30), loosen the 2 "torx" screws until the groove along the screw circumference catches on the screw case.



    C111064

  1. Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand as shown in the illustration.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.

  1. Disconnect the horn connector.

  1. Disconnect the 2 connectors from the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Remove the steering pad.



7. REMOVE STEERING WHEEL ASSEMBLY

  1. Remove the steering wheel assembly set nut.

  1. Put matchmarks on the steering wheel assembly and main shaft assembly.



    C111427E01

  1. Using SST, remove the steering wheel assembly.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)



8. REMOVE STEERING COLUMN COVER (for Manual Tilt)


    C111428E01

  1. Remove the steering column cover lower No.2.

  1. Remove the 3 screws.

  1. Disengage the 2 claws and remove the steering column cover lower.



    C111431

  1. Disengage the claw and remove the steering column cover upper.



9. REMOVE STEERING COLUMN COVER (for Power Tilt and Power Telescopic)


    C111471

  1. Remove the 3 screws.

  1. Disengage the 2 claws and remove the steering column cover lower.

    NOTICE:
    Do not damage the tilt and telescopic switch.



    C111431

  1. Disengage the claw and remove the steering column cover upper.



10. REMOVE SPIRAL CABLE


    C111113

  1. Disconnect the connectors from the spiral cable.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Disengage the 3 claws and remove the spiral cable.



11. REMOVE WIPER SWITCH


    I037265E01

  1. Disconnect the connector.

  1. Using a screwdriver wrapped with protective tape, disengage the claw and remove the wiper switch.

    NOTICE:
    If the claw is pushed with excessive force, it may be broken.



12. REMOVE HEADLIGHT DIMMER SWITCH


    I037768E02

  1. Disconnect the connector.

  1. Disengage the claw as shown in the illustration.



    E068372E04

  1. Remove the headlight dimmer switch as shown in the illustration.