FRONT WIPER MOTOR > INSTALLATION

for Preparation Click here



1. INSTALL FRONT WIPER MOTOR


    I035810

  1. Install the front wiper motor with the 3 bolts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. Apply MP grease to the crank arm pivot of the front wiper motor.



    I035809E01

  1. Align the matchmarks on the crank arm and front wiper motor, then install the washer and nut.

    Torque:
    17 N*m{ 175 kgf*cm , 13 ft.*lbf }

  1. Install the rod to the crank arm pivot of the front wiper motor.



2. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY


    E110471

  1. Install the windshield wiper motor and link assembly with the 5 bolts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }

  1. Connect the connector.



3. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY


4. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH


    B108016E03

  1. Operate the front wiper, and stop the front wiper motor at the automatic stop position.

  1. Clean the wiper arm serrations.

  1. Clean the wiper pivot serrations with a wire brush (when reinstalling).



    E069045E01

  1. Install the front wiper arm and blade assembly LH with the nut at the position as shown in the illustration.

    Torque:
    24 N*m{ 245 kgf*cm , 18 ft.*lbf }

    HINT:
    Hold the arm hinge by hand to fasten the nut.



5. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH


    B108016E03

  1. Clean the wiper arm serrations.

  1. Clean the wiper pivot serrations with a wire brush (when reinstalling).



    E069046E01

  1. Install the front wiper arm and blade assembly RH with the 2 nuts at the position as shown in the illustration.

    Torque:
    24 N*m{ 245 kgf*cm , 18 ft.*lbf }

    HINT:
    Hold the arm hinge by hand to fasten the nut.

  1. Operate the front wipers while spraying water or washer fluid on the windshield.

  1. Make sure that the wipers function properly and there is no interference with the vehicle body.