FRONT WIPER MOTOR > REMOVAL

for Preparation Click here



1. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH

  1. Remove the 2 nuts and the front wiper arm and blade assembly RH.



2. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH

  1. Remove the nut and the front wiper arm and blade assembly LH.



3. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY


    E110470

  1. Remove the 2 clips.

  1. Disengage the 6 claws and the clamp, and remove the cowl top ventilator louver sub-assembly.



4. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY


    E110471E01

  1. Disconnect the connector.

  1. Remove the 5 bolts and the windshield wiper motor and link assembly.

    HINT:
    Bolt <A> cannot be removed because it is integrated into windshield wiper link assembly.



5. REMOVE FRONT WIPER MOTOR


    I035808E01

  1. Using a screwdriver wrapped with protective tape, separate the rod of the windshield wiper link assembly from the front wiper motor as shown in the illustration.



    I035809E01

  1. Remove the nut and washer.

  1. Put the matchmarks on the crank arm and front wiper motor.



    I035810

  1. Remove the 3 bolts and front wiper motor from the windshield wiper link assembly.