HOOD > DISASSEMBLY

for Preparation Click here



1. REMOVE AUXILIARY CATCH RELEASE LEVER ASSEMBLY


    B069271

  1. Remove the 3 bolts, auxiliary catch release lever assembly and hood auxiliary catch hook assembly as a unit.

  1. Remove the auxiliary catch release lever assembly from the hood auxiliary catch hook assembly.



2. REMOVE RADIATOR GRILLE


    B113706

  1. Remove the 5 nuts, clip and radiator grille.



3. REMOVE HOOD INSULATOR


    B069277

  1. Remove the 8 clips and hood insulator.



4. REMOVE HOOD SUPPORT ROD

NOTICE:
  1. While supporting the hood sub-assembly by hand, remove the hood support rod.
  2. Do not touch the extendable portion of the rod to prevent foreign objects from attaching to the rod surface.
  3. Do not push sideways on the rod because the rod may bend.



    B067833E02

  1. Using a screwdriver, remove the clip and hood support rod from the hood sub-assembly.

  1. Remove the bolt and the hood support rod.



5. REMOVE HOOD TO RADIATOR SUPPORT SEAL


6. REMOVE HOOD TO FRONT FENDER SEAL LH


7. REMOVE HOOD TO FRONT FENDER SEAL RH


8. REMOVE HOOD SUB-ASSEMBLY


    B069273

  1. Remove the 2 bolts.

    HINT:
    Use the same procedure for removal on the RH side.

  1. Remove the hood sub-assembly.



9. REMOVE HOOD HINGE ASSEMBLY LH


    B069272

  1. Remove the 2 bolts and hood hinge assembly LH.



10. REMOVE HOOD HINGE ASSEMBLY RH

  1. Remove the 2 bolts and hood hinge assembly RH.



11. REMOVE COOL AIR INTAKE DUCT SEAL


    B069269

  1. Remove the 4 clips and cool air intake duct seal.



12. REMOVE HOOD LOCK CONTROL CABLE COVER


    B069267

  1. Remove the 2 screws and disengage the 2 claws and remove the hood lock control cable cover.



13. REMOVE HOOD LOCK ASSEMBLY


    B070443E02

  1. Using a screwdriver wrapped with protective tape, remove the nut cap.



    B069274E01

  1. Remove the 3 bolts and separate the hood lock assembly.

  1. Disconnect the connector and cable.

  1. Remove the hood lock assembly.



14. REMOVE CUSHION RUBBER