REAR DOOR > ADJUSTMENT

for Preparation Click here

1. Check that the clearance is within the standard range.
   
   

   
   
   
   

   Standard range: 

   A	4.5 +- 1.5 mm (0.177+-0.059 in.)
   B	4.8 +- 1.5 mm (0.189+-0.059 in.)
   C	5.1 +- 1.5 mm (0.201+-0.059 in.)
   D	6.8 +- 1.5 mm (0.268+-0.059 in.)
   E	4.5 +- 1.5 mm (0.177+-0.059 in.)

1. Loosen the bolts on the pillar side to adjust the door front and back, up and down.
   

   Torque:

   26 N*m{ 265 kgf*cm , 19 ft.*lbf }

2. Loosen the bolts on the door side to adjust the door up and down, and the door front side to side.
   

   Torque:

   27 N*m{ 275 kgf*cm , 20 ft.*lbf }

   HINT:

   Perform this procedure after replacing the centering bolt with the supplied bolt.

3. When adjusting the door rear side to side and the rear door lock striker plate assembly, use a "torx" socket wrench (T40), to loosen the screws until the striker can move. Lightly tap it with a brass bar for adjustment.
   

   Torque:

   23 N*m{ 235 kgf*cm , 17 ft.*lbf }