BACK DOOR > ADJUSTMENT

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
(Click here)


2. INSPECT BACK DOOR


  1. Check that the clearance is within the standard range.


    B113682E01

    Standard range: 
    A
    		6.5 +- 2.0 mm (0.256 +- 0.078 in.)
    B
    		8.1 +- 2.0 mm (0.319 +- 0.078 in.)
    C
    		1.0 +- 2.0 mm (0.039 +- 0.078 in.)
    D
    		5.5 +- 1.5 mm (0.217 +- 0.059 in.)
    E
    		0 +- 1.5 mm (0 +- 0.059 in.)



3. ADJUST BACK DOOR


    B069954

  1. Loosen the body side hinge nuts and adjust the door right, left, forward, and rearward.

    Torque:
    19.5 N*m{ 199 kgf*cm , 14 ft.*lbf }



    B069955E01

  1. Horizontally and vertically adjust the back door by loosening the back door side hinge bolts.

    Torque:
    19.5 N*m{ 199 kgf*cm , 14 ft.*lbf }



    B068319

  1. When adjusting the back door rear side to side and the back door lock striker assembly, loosen the bolts until the striker can move. Lightly tap striker with a brass bar for adjustment.

    Torque:
    23 N*m{ 235 kgf*cm , 17 ft.*lbf }



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


5. PERFORM INITIALIZATION
(Click here)