DTC    B2421    Steering Neutral Point Automatic Correction Incompletion

for Preparation Click here


DESCRIPTION

This DTC is output when AFS ECU does not finish steering neutral point automatic correction. AFS operation is prohibited while this DTC is being output. This DTC is completed and AFS operation starts when AFS ECU records the steering neutral point correctly. If this DTC is not automatically erased, perform repair or replacement by following the procedures below.

DTC No.
DTC Detecting Condition
Trouble Area
B2421
  1. Steering neutral point correction recording
  2. Steering position sensor circuit
  1. Steering sensor
  2. Harness or connector
  3. Skid Control ECU
  4. AFS ECU

INSPECTION PROCEDURE

1.CHECK DTC

  1. Check that DTC B2414 and B2415 is not output (Click here).

    OK:
    DTC is not output.



NG
GO TO FLOW CHART
OK


2.AFS ECU RE-INITIALIZATION

  1. Return to normal condition.

    OK:
    DTC is not output.



NG
REPLACE AFS ECU
OK

END