POWER WINDOW CONTROL SYSTEM
Symptom
| Suspected area
| See page
|
Power window does not operate with multiplex network master switch operation
| 1. ECU-B, ECU-IG, PWR fuse
| -
|
2. Multiplex network master switch circuit (power source)
|
Click here
|
3. Power window regulator motor circuit
|
Click here
|
4. Multiplex network master switch
| -
|
Power window does not operate with multiplex network switch operation (front passenger side)
| 1. PWR fuse
| -
|
2. Multiplex network switch circuit (power source)
|
Click here
|
3. Power window regulator motor circuit (front passenger side)
|
Click here
|
4. Multiplex network switch (front passenger side)
| -
|
Power window does not operate with multiplex network switch operation (rear LH side)
| 1. PWR fuse
| -
|
2. Multiplex network switch circuit (power source)
|
Click here
|
3. Power window regulator motor circuit (rear LH side)
|
Click here
|
4. Multiplex network switch (rear LH side)
| -
|
Power window does not operate with multiplex network switch operation (rear RH side)
| 1. PWR fuse
| -
|
2. Multiplex network switch circuit (power source)
|
Click here
|
3. Power window regulator motor circuit (rear RH side)
|
Click here
|
4. Multiplex network switch (rear RH side)
| -
|
AUTO UP/DOWN function does not operate on driver side
| 1. Diagnosis check
|
Click here
|
2. Power window regulator motor reset
|
Click here
|
3. Multiplex network master switch
| -
|
4. Wire harness
| -
|
AUTO UP/DOWN function does not operate on any door side except driver sides
| 1. Diagnosis check
|
Click here
|
2. Power window regulator motor reset
|
Click here
|
3. Multiplex network master switch
| -
|
4. Wire harness
| -
|
Remote UP/DOWN function does not operate
| 1. DATA LIST/ACTIVE TEST
|
Click here
|
2. Multiplex network master switch
|
Click here
|
3. Multiplex network body ECU
| -
|
4. Wire harness
| -
|
Power window can be operated after ignition switch is turned off even if operated conditions are not met
| 1. Front door courtesy switch
|
Click here
|
2. Wire harness
| -
|
AUTO UP operation does not fully close power window (Jam protection function is activated)
| 1. Power window regulator motor reset
|
Click here
|
2. Check & Clean Glass run
| -
|
3. Multiplex network master switch
| -
|
