POWER MIRROR CONTROL SYSTEM (w/ Memory) > DATA LIST / ACTIVE TEST

for Preparation Click here



USING INTELLIGENT TESTER
E109221E03

  1. Connect the intelligent tester to the DLC3.

  2. Monitor the ECU data by following the prompts on the tester screen.

    HINT:
    The intelligent tester has a "Snapshot" function which records the monitored data. Refer to the intelligent tester operator's manual for further details.


DATA LIST

HINT:
Using the DATA LIST displayed on the intelligent tester, you can read the value of the switch, sensor, actuator, etc. without parts removal. Reading the DATA LIST as the first step of troubleshooting is one way to shorten the labor time.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch ON.

  3. Read the DATA LIST according to the display on the tester.

    Item
    		Test Details
    		Diagnostic Note
    Mirror Selection SW (R)
    		Mirror selection switch signal for RH mirror/ON or OFF
    		ON: Switch is in Right position
    OFF: Switch is in neutral or Left position
    Mirror Selection SW (L)
    		Mirror selection switch signal for LH mirror/ON or OFF
    		ON: Switch is in Left position
    OFF: Switch is in neutral or Right position
    Mirror Position SW (R)
    		Mirror position switch signal (Right)/ON or OFF
    		ON: Switch R is ON
    OFF: Any switch except R is ON or all switches are OFF
    Mirror Position SW (L)
    		Mirror position switch signal (Left)/ON or OFF
    		ON: Switch L is ON
    OFF: Any switch except L is ON or all switches are OFF
    Mirror Position SW (Up)
    		Mirror position switch signal (Up)/ON or OFF
    		ON: Switch UP is ON
    OFF: Any switch except UP is ON or all switches are OFF
    Mirror Position SW (Dwn)
    		Mirror position switch signal (Down)/ON or OFF
    		ON: Switch DOWN is ON
    OFF: Any switch except DOWN is ON or all switches are OFF
    Outer Mirror Fold SW
    		Retract switch position signal/ON or OFF
    		ON: Retracted position
    OFF: Driving position