KEY REMINDER WARNING SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



READ DATA LIST

HINT:
Using the intelligent tester's DATA LIST allows switch, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch ON.

  3. Read the DATA LIST.

    Body ECU: 
    Item
    		Measurement Item /
    Display (Range)
    		Normal Condition
    		Diagnostic Note
    Key Unlock Warning SW
    		Unlock warning switch signal
    /ON or OFF
    		ON: Key is in ignition key cylinder
    OFF: No key is in ignition key cylinder
    		-
    D Door Courtesy SW
    		Driver side door courtesy switch signal
    /ON or OFF
    		ON: Driver side door is open
    OFF: Driver side door is closed
    		-


PERFORM ACTIVE TEST

HINT:
Performing the intelligent tester's ACTIVE TEST allows relay, VSV, actuator, and other items to be operated without removing any parts. Performing the ACTIVE TEST early in troubleshooting is one way to save time. The DATA LIST can be displayed during the ACTIVE TEST.

  1. Connect the intelligent tester with CAN VIM to the DLC3.

  2. Turn the ignition switch ON.

  3. Perform the ACTIVE TEST.

    METER: 
    Item
    		Test Details
    		Diagnostic Note
    Key Remained Buzzer
    		Key reminder buzzer (OFF/ON)
    		Confirm that the vehicle is stopped, engine idling