ENGINE REAR OIL SEAL > INSTALLATION

for Preparation Click here

1. Apply MP grease to a new oil seal lip.
   

   NOTICE:

   Keep the lip free from foreign objects.

2. Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.
   

   SST

   09223-15030  
   09950-70010   (09951-07100)
   

   NOTICE:

   1. Do not tap the oil seal at an angle.
      
   2. Wipe off extra grease on the crankshaft.
      

1. Using SST, hold the crankshaft.
   

   SST

   09213-54015   (91651-60855)
   09330-00021  
   

2. Clean the bolts and bolt holes.
   

3. Apply adhesive to 2 or 3 threads of the bolts.
   

   Adhesive:

   Part No.08833-00070, THREE BOND 1324 or equivalent
   

4. Install the flywheel on the crankshaft.
   

5. Using several steps, install and tighten the 8 bolts uniformly in the sequence shown in the illustration.
   

   Torque:

   83 N*m{ 846 kgf*cm , 61 ft.*lbf }

   NOTICE:

   Do not start the engine within 1 hour after installing.

1. Using SST, hold the crankshaft.
   

   SST

   09213-54015   (91651-60855)
   09330-00021  
   

2. Install the 6 bolts and transmission input damper.
   

   Torque:

   30 N*m{ 306 kgf*cm , 22 ft.*lbf }

   HINT:

   Take care not to insert the transmission input damper in the wrong direction.