ENGINE REAR OIL SEAL > REMOVAL

for Preparation Click here



1. REMOVE HYBRID VEHICLE TRANSAXLE ASSEMBLY
(Click here)


2. REMOVE TRANSMISSION INPUT DAMPER ASSEMBLY


    A109808E01

  1. Using SST, hold the crankshaft.

    SST
    09213-54015   (91651-60855)
    09330-00021  



    A108131

  1. Remove the 6 bolts and transmission input damper from the flywheel.



3. REMOVE FLYWHEEL SUB-ASSEMBLY


    A109808E01

  1. Using SST, hold the crankshaft.

    SST
    09213-54015   (91651-60855)
    09330-00021  



    A108132

  1. Remove the 8 bolts and flywheel.



4. REMOVE ENGINE REAR OIL SEAL


    A078768E01

  1. Using a knife, cut off the oil seal lip.

  1. Using a screwdriver with the tip taped, pry out the oil seal.

    NOTICE:
    After the removal, check that the crankshaft is not damaged. If it is damaged, smooth the surface with 400-grit sandpaper.