METER / GAUGE SYSTEM > PRECAUTION

for Preparation Click here



1.REMOVAL AND INSTALLATION OF THE BATTERY TERMINAL


    E110592E01

  1. Before performing electrical work, disconnect the battery negative (-) terminal in order to prevent a short in the system.

  2. When disconnecting and reconnecting the battery cable, turn the ignition switch and lighting switches off and loosen the terminal nut completely. Perform these operations without prying on the terminal.

  3. When the battery terminal is removed, the memories of the clock, radio, DTCs, etc. are erased. So before removing the terminal, check and make a note of them.

    NOTICE:
    When disconnecting the battery negative (-) terminal, initialize the following system after the terminal is reconnected.

    System Name
    		See Procedure
    Lighting System
    		 Click here
    Sliding Roof Control System
    Occupant Classification System
    Power Window Control System
    Power Door Lock Control System
    Power Back Door System
    Theft Deterrent System
    Air Conditioning System
    Wireless Door Lock Control System
    Wiper And Washer System
    Power Tilt And Power Telescopic Steering Column