METER / GAUGE SYSTEM > Entire Combination Meter does not Operate

for Preparation Click here


WIRING DIAGRAM


E110182E01


INSPECTION PROCEDURE

1.INSPECT COMBINATION METER ASSEMBLY


    E110175E03

  1. Disconnect the C8 and C9 connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    		Condition
    		Specified Condition
    C8-1 (POWER GND)
    - Body ground
    		Always
    		Below 1 Ω
    C9-1 (SIGNAL GND)
    - Body ground
    		Always
    		Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    		Condition
    		Specified Condition
    C8-8 (IG2) -
    Body ground
    		Turn the ignition switch to the ON position
    		10 to 16 V
    C8-15 (ECU +B) -
    Body ground
    		Always
    		10 to 16 V
    C8-16 (DOME +B) -
    Body ground
    		Always
    		10 to 16 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY