REAR SEAT ASSEMBLY (for LH Side) > DISASSEMBLY

for Preparation Click here

1. Remove the 2 screws.
   

2. Disengage the claw and remove the rear seat cushion moulding LH as shown in the illustration.
   

1. Remove the 3 screws.
   

2. Disengage the 3 claws and remove the rear seat cushion moulding rear LH.
   

1. Using a "torx" socket wrench (T45), remove the 2 "torx" bolts.
   

2. Release the 2 rubber bands on the backside of the rear seatback board carpet assembly.
   

3. Remove the hog rings.
   

4. Remove the 2 bolts and separate type rear seat cushion assembly.
   

1. Disengage the hooks and remove the hog rings and rear seat cushion frame sub-assembly.
   

1. Remove the hog rings and separate type rear seat cushion cover.
   

1. Disengage the bolt and remove the rear seat belt assembly inner.
   

1. Using a moulding remover, disengage the 4 claws and remove the rear seatback cover.
   

1. Disengage the 4 clips and remove the rear seatback board carpet assembly.
   

1. Using a screwdriver, disengage the 2 claws and remove the rear seatback lock striker cover.
   

   HINT:

   Tape the screwdriver tip before use.

1. Remove the 2 screws.
   

2. Disconnect the rear seat reclining control No.2 cable and remove the rear seat lock control lever sub-assembly.
   

1. Disengage the 2 claws and remove the rear seat headrest support (LH side).
   

HINT:

Use the same procedures described for the LH side.

1. Remove the 2 clips.
   

2. Remove the bolt and rear seat belt hook.
   

3. Disengage the hooks and remove the hog rings and separate type rear seatback cover with pad.
   

1. Remove the hog rings and separate type rear seatback cover.
   

1. Remove the bolt and fold seat stopper band assembly No.2.
   

1. Remove the screw.
   

2. Disengage the claw and remove the rear seat reclining cover inner LH.
   

1. Remove the screw and rear seat cover No.2.
   

1. Disconnect the 2 cables and remove the rear seat reclining control No.2 cable.
   

1. Using a "torx" socket wrench (T45), remove the 4 "torx" bolts and rear seatback frame sub-assembly.
   

1. Remove the clamp.
   

2. Disconnect the 2 seat track stop plate cables.
   

3. Remove the 2 nuts and seat track stop plate.
   

1. Remove the E-ring and spring.
   

2. Remove the 4 nuts and reclining control link sub-assembly.
   

1. Using a "torx" socket wrench (T45), remove the 5 "torx" bolts and rear seatback frame sub-assembly lower.
   

1. Remove the 4 nuts and 2 fold seat cushion frame No.1.
   

1. Move the rear seat track assembly outer and rear seat track assembly inner fully forward by operating the rear seat track adjusting handle.
   

2. Using a hexagon wrench 1.5 mm (0.059 in.), push down the 2 handle stoppers as shown in the illustration and remove the rear seat track adjusting handle.