FRONT AXLE HUB BOLT > REPLACEMENT

for Preparation Click here



1. REMOVE FRONT WHEEL


2. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY


    C108159

  1. Remove the 2 bolts, and separate the brake caliper assembly.

    NOTICE:
    Use a wire or an equivalent to keep the brake caliper from hanging down by the flexible hose.



3. REMOVE FRONT DISC


C113676E01

HINT:
Put matchmarks on the disc and the axle hub.



4. REMOVE FRONT AXLE HUB BOLT


    C112993E01

  1. Temporarily install the 2 nuts and washers to the front axle hub bolt as shown in the illustration.

  1. Using SST and a brass bar or an equivalent to hold the front axle, remove the front axle hub bolt.

    SST
    09628-10011  



5. INSTALL FRONT AXLE HUB BOLT


    C108165E01

  1. Install a washer and nut to a new front axle hub bolt as shown in the illustration.

  1. Using a brass bar to hold the front axle, install the hub bolt by torquing the nut.



6. INSTALL FRONT DISC


    C113676E01

  1. Align the matchmarks and install the front disc.

    NOTICE:
    When replacing the disc with a new one, select the installation position where the front disc has the minimum runout.



7. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY


    C108159

  1. Install the front disc brake caliper assembly with the 2 bolts to the steering knuckle.

    Torque:
    104 N*m{ 1,060 kgf*cm , 77 ft.*lbf }



8. INSTALL FRONT WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }