VVT SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL VVT SENSOR (for Bank 1)


    A079541E01

  1. Apply a light coat of engine oil to the O-ring on the VVT sensor (Bank 1).

  1. Install the VVT sensor (Bank 1) with the bolt.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the VVT sensor (Bank 1) connector.



2. INSTALL VVT SENSOR (for Bank 2)


    A078529E01

  1. Apply a light coat of engine oil to the O-ring on the VVT sensor (Bank 2).

  1. Install the VVT sensor (Bank 2) with the bolt.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the VVT sensor (Bank 2) connector.



    A108296E01

  1. Install the heated oxygen sensor connector (Bank 2) to the wire harness bracket.



3. INSTALL AIR CLEANER CAP W/ INLET

  1. Install the air cleaner filter element to the air cleaner case.



    A108124

  1. Install the 2 bolts, 4 clamps and air cleaner cap w/ inlet.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }



4. INSTALL COOL AIR INTAKE DUCT SEAL

  1. Install the 4 clips and cool air intake duct seal.