POWER WINDOW CONTROL SYSTEM > Rear Power Window Switch LH Circuit

for Preparation Click here


DESCRIPTION

This circuit supplies power to operate the multiplex network switch.

WIRING DIAGRAM


B111209E11


INSPECTION PROCEDURE

1.CHECK WIRE HARNESS (MULTIPLEX NETWORK SWITCH - BATTERY AND BODY GROUND)


    B111210E06

  1. Disconnect the P17 connector.

  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    		Condition
    		Specified Condition
    P17-12 (BDR) - Body ground
    		Always
    		10 to 14 V

    Standard resistance:
    Tester Connection
    		Condition
    		Specified Condition
    P17-7 (GND) - Body ground
    		Always
    		Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE