ENGINE COOLANT TEMPERATURE SENSOR > INSPECTION

for Preparation Click here



1. INSPECT ENGINE COOLANT TEMPERATURE SENSOR


    A114776E01

  1. Using an ohmmeter, measure the resistance between the terminals.

    Standard resistance:
    Condition
    		Specified Condition
    20°C (68°F)
    		2.32 to 2.59 kΩ
    80°C (176°F)
    		0.310 to 0.326 kΩ

    If the result is not as specified, replace the sensor.

    NOTICE:
    In case of checking the water temperature sensor in the water, do not allow water to go into the terminals. After checking, dry the sensor.