CRANKSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL CRANKSHAFT POSITION SENSOR

  1. Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.



    A079763

  1. Install the crankshaft position sensor with the bolt.

    Torque:
    8.0 N*m{ 80 kgf*cm , 71 in.*lbf }

  1. Connect the crankshaft position sensor connector.



2. INSTALL FRONT FENDER APRON SEAL RH


    A080512

  1. Install the front fender apron seal RH with the clip and 2 bolts.



3. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH


    A112019E01

  1. Install the front fender splash shield sub-assembly RH with the screw.



4. INSTALL ENGINE UNDER COVER NO.1


    A108722

  1. Install the 6 bolts, 2 screws, 2 clips and engine under cover.