CRANKSHAFT POSITION SENSOR > REMOVAL

for Preparation Click here



1. REMOVE ENGINE UNDER COVER NO.1


    A108722

  1. Remove the 6 bolts, 2 screws, 2 clips and engine under cover.



2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH


    A080511

  1. Remove the screw, and then open the front fender splash shield sub-assembly RH.



3. REMOVE FRONT FENDER APRON SEAL RH


    A080512

  1. Remove the clip and 2 bolts, and then remove the front fender apron seal RH.



4. REMOVE CRANKSHAFT POSITION SENSOR


    A079763

  1. Disconnect the crankshaft position sensor connector.

  1. Remove the bolt, and then remove the crankshaft position sensor.