HEATED OXYGEN SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL OXYGEN SENSOR

  1. Temporarily tighten the oxygen sensor to the exhaust pipe sub-assembly front No.3.

    NOTICE:
    Do not to damage the oxygen sensor.



    A108665E01

  1. Using SST, fully tighten the oxygen sensor to the exhaust pipe sub-assembly front No.3.

    SST
    09224-00010  

    Torque:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }



    A108663

  1. Connect the oxygen sensor connector and clamp.



2. INSTALL OXYGEN NO.2 SENSOR

  1. Temporarily tighten the oxygen sensor No.2 to the exhaust pipe sub-assembly front.

    NOTICE:
    Do not to damage the oxygen sensor.



    A108681E01

  1. Using SST, fully tighten the oxygen sensor No.2 to the exhaust pipe sub-assembly front.

    SST
    09224-00010  

    Torque:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }



    A108666

  1. Connect the oxygen sensor No.2 connector.