ROOF DRIP SIDE FINISH MOULDING > REMOVAL

for Preparation Click here



1. REMOVE ROOF DRIP SIDE MOULDING COVER FRONT


    B069678

  1. Using a remover for the moulding cover, disengage the clip and claw, and remove the moulding cover.



2. REMOVE ROOF DRIP SIDE FINISH MOULDING


    B069679E01

  1. Tape the circumference of the moulding for protection.

  1. Using a remover for the roof moulding, release the engagements of the clips and remove the moulding.

    NOTICE:
    1. Do not remove the clips.
    2. In case that the clips are damaged or removed accidentally, replace them with new ones.



3. REMOVE ROOF DRIP SIDE FINISH MOULDING CENTER


    B069680E02

  1. Tape the circumference of the moulding for protection.

  1. Using a remover for the roof moulding, release the engagements of the clips and remove the moulding.



4. REMOVE ROOF DRIP SIDE FINISH MOULDING REAR


    B069681E01

  1. Tape the circumference of the moulding for protection.

  1. Using a remover for the roof moulding, release the engagements of the clips and remove the moulding.

    NOTICE:
    1. Do not remove the clips,
    2. In case that the clips are damages or removed accidentally, replace them with new ones.