OUTSIDE MOULDING > REMOVAL

for Preparation Click here



1. REMOVE OUTSIDE MOULDING


    B071027E01

  1. Using a heat light, heat the moulding.

    Heating temperature:
    40 to 60°C (104 to140°F)

    NOTICE:
    Do not heat the moulding excessively.

  1. Tie both the piano wire ends to wooden blocks or equivalents.

  1. Scrape tape off by pulling the piano wire and remove the moulding with reference pins remaining on the moulding.

    NOTICE:
    1. If reusing the moulding, take care not to damage the moulding.
    2. Do not damage the body.

  1. Remove the moulding.