FRONT DOOR BELT MOULDING > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG


    B069406

  1. Using a screwdriver wrapped with protective tape, disengage the 3 claws and remove the front door inside handle bezel plug.



2. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY


    B068618

  1. Using a screwdriver wrapped with protective tape, disengage the 2 claws and the 2 clips.

  1. Disconnect the connector and remove the power window regulator master switch assembly.



3. REMOVE DOOR ARMREST COVER


    B112313

  1. Remove the door armrest cover.



4. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH


    B068804E01

  1. Using a screwdriver wrapped with protective tape, disengage the 2 clips and claw, and remove the front door lower frame bracket garnish.



5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY


    B112314E01

  1. Remove the 2 screws.

  1. Remove the clip <A>.

  1. Pulling the front door trim board sub-assembly in the direction of the arrow shown in the illustration, disengage the 15 clips <B>.

  1. Disconnect the cables and each connector from the back side of the inside handle and the front door trim board sub-assembly, remove the front door trim board sub-assembly.



    B112315

  1. Disengage the 2 claws and remove the front door courtesy light.



6. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY


    B112347

  1. Disconnect the connector and remove the clamp.

  1. Remove the 3 bolts and the outer rear view mirror assembly.



7. REMOVE FRONT DOOR BELT MOULDING ASSEMBLY


    B068604E01

  1. Put protective tape under the moulding.

  1. Using a moulding remover, disengage the claws and remove the front door belt moulding assembly.

    HINT:
    Tape the remover tip before use.