REAR DOOR BELT MOULDING > REMOVAL

for Preparation Click here



1. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG


    B069469

  1. Using a screwdriver wrapped with protective tape, disengage the 3 claws and remove the rear door inside handle bezel plug.



2. REMOVE REAR DOOR ARMREST BASE PANEL ASSEMBLY


    B068811

  1. Using a screwdriver wrapped with protective tape, disengage the 2 claws and 2 clips.

  1. Disconnect the connector and remove the rear door armrest base panel assembly.



3. REMOVE REAR DOOR ARMREST COVER


    B112331

  1. Remove the rear door armrest cover.



4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY


    B112332E01

  1. Remove the 2 screws.

  1. Pulling the front door trim board sub-assembly in the direction of the arrow shown in the illustration, disengage the 13 clips.

  1. Disconnect the cable and each connector from the inside handle and the rear door trim board sub-assembly, remove the rear door trim board sub-assembly.



5. REMOVE REAR DOOR BELT MOULDING ASSEMBLY


    B068605E01

  1. Put protective tape under the moulding.

  1. Using a moulding remover, disengage the claws and remove the rear door belt moulding assembly LH.

    HINT:
    Tape the remover tip before use.