STEREO COMPONENT AMPLIFIER > INSTALLATION

for Preparation Click here



1. INSTALL STEREO COMPONENT AMPLIFIER (w/ Mark Levinson System)


    E113295

  1. Install the No.2 amplifier bracket with the 2 bolts.



    E113294

  1. Install the No.1 amplifier bracket with the 2 bolts.



    E113054

  1. Connect the 4 connectors.

  1. Install the stereo component amplifier with the 2 bolts and the nut.



2. INSTALL STEREO COMPONENT AMPLIFIER (w/o Mark Levinson System)


    E113057

  1. Connect the 2 connectors.

  1. Install the stereo component amplifier with the 2 bolts and the nut.



3. INSTALL REAR SEAT SUB FLOOR PANEL ASSEMBLY


    E109849

  1. Install the rear seat sub floor panel assembly with the 3 bolts and the 3 nuts.



4. INSTALL DECK SIDE TRIM BOX LH


    B111781

  1. Install the deck side trim box with the 2 clips.



5. INSTALL DECK SIDE TRIM BOX RH


6. INSTALL JACK CARRIER ASSEMBLY

  1. Install the jack carrier assembly, jack assembly and jack carrier support.



7. INSTALL REAR FLOOR FINISH PLATE


    B110477

  1. Engage the 2 claws and 6 clips, and install the rear floor finish plate.

  1. Install the 2 clips.



8. INSTALL NO.3 DECK BOARD SUB-ASSEMBLY


    B110025

  1. Install the deck No.3 board sub-assembly with the 2 bolts and 2 nuts.



9. INSTALL NO.2 DECK BOARD SUB-ASSEMBLY


    B110024

  1. Install the deck No.2 board sub-assembly with the 4 bolts and 2 nuts.



10. INSTALL DECK FLOOR BOX REAR


    B110023

  1. Install the deck floor box rear with the 2 clips.



11. INSTALL DECK FLOOR BOX FRONT


    B110022

  1. Install the deck floor box front with the 2 clips.



12. INSTALL DECK BOARD SUB-ASSEMBLY


    B110455

  1. Install the deck board sub-assembly with the 2 bolt.

  1. Engage the 5 clips.



13. INSTALL TONNEAU COVER ASSEMBLY


14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


15. PERFORM INITIALIZATION

NOTICE:
Some systems need initialization when disconnecting the cable from the negative battery terminal. (Click here)