STEREO COMPONENT AMPLIFIER > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE TONNEAU COVER ASSEMBLY


3. REMOVE DECK BOARD SUB-ASSEMBLY


    B110021

  1. Disengage the 5 clips and turn up the front side of the deck board.

  1. Remove the 2 bolts and deck board sub-assembly.



4. REMOVE DECK FLOOR BOX FRONT


    B110022

  1. Using a clip remover, remove the 2 clips and deck floor box front.



5. REMOVE DECK FLOOR BOX REAR


    B110023

  1. Using a clip remover, remove the 2 clips and deck floor box rear.



6. REMOVE NO.3 DECK BOARD SUB-ASSEMBLY


    B110025

  1. Remove the 2 bolts, 2 nuts and deck No.3 board sub-assembly.



7. REMOVE NO.2 DECK BOARD SUB-ASSEMBLY


    B110024

  1. Remove the 4 blots, 2 nuts and deck No.2 board sub-assembly.



8. REMOVE REAR FLOOR FINISH PLATE


    B111780

  1. Using a clip remover, remove the 2 clips.

  1. Disengage the 2 claws and 6 clips, and remove the rear floor finish plate.



9. REMOVE JACK CARRIER ASSEMBLY

  1. Remove the jack carrier support, jack assembly and jack carrier assembly.



10. REMOVE DECK SIDE TRIM BOX LH


    B111781E01

  1. Remove the clip (A).

  1. Using a clip remover, remove the clip (B) and deck side trim box.



11. REMOVE DECK SIDE TRIM BOX RH


12. REMOVE REAR SEAT SUB FLOOR PANEL ASSEMBLY


    E109849

  1. Remove the 3 bolts, the 3 nuts and the rear seat sub floor panel assembly.



13. REMOVE STEREO COMPONENT AMPLIFIER (w/o Mark Levinson System)


    E113057

  1. Remove the 2 bolts and the nut.

  1. Disconnect the 2 connectors and remove the stereo component amplifier.



14. REMOVE STEREO COMPONENT AMPLIFIER (w/ Mark Levinson System)


    E113054

  1. Remove the 2 bolts and the nut.

  1. Disconnect the 4 connectors and remove the stereo component amplifier.



    E113294

  1. Remove the 2 bolts and the No.1 amplifier bracket.



    E113295

  1. Remove the 2 bolts and the No.2 amplifier bracket.